HDX 501HDX Guía De Uso Y Cuidado página 3

Assembly
1
Attaching the hose to the tank
Insert the pink siphon tube (E)

approximately ½ in. into the pink hose
insert (1) otherwise sprayer will spray only
air.
Lubricate the black o-ring (2) on the pink

hose insert (1) and then push into the
threaded tank nipple (3) on the tank (A) until
fully seated.
Screw the hose nut (4) onto the threaded

tank nipple (3). Firmly hand tighten and pull
to ensure a tight connection.
2
4
3
Operation
1
Filling the sprayer
WARNING:
(i.e. acids, chlorines and bleach), corrosive,
heated, or self-heating solutions with this
sprayer.
Remove the pump assembly (F) from the

tank (A) by locking the pump handle down,
then turning counterclockwise.
Prepare the spray solution following

the instructions listed on the chemical
manufacturers' label. Mix only the amount
FILL LINE).
Screw the pump assembly (F) back into the

tank (A) by turning clockwise. Firmly hand
tighten.
F
A
E
1
A
2
Attaching the flow control to the hose

hose (B).
Push the hose (B) over the pointed end of

of the threads.

pull to ensure a tight connection.
1 B
2
Pressurizing the sprayer
WARNING: To prevent the ejected pump
assembly and/or solution from striking and
injuring you, never stand with your face or body
directly over the top of the tanks when pumping
or loosening the pump.
To operate the pump (F), unlock the pump

handle by turning counterclockwise. Be
careful not to loosen the pump (F) from the
tank (A).
To create pressure, move the pump handle

up and down until it is hard to pump.
Lock the pump handle back into the pump

assembly (F) by turning clockwise.
F
A
C