Universal Forest Products Lightning Instrucciones De Instalación

LIGHTNING RAIL
INSTALLATION INSTRUCTIONS
Tools Needed
• Drill/power screwdriver
• Miter or circular saw
with carbide tip blade
• Tape measure
Planning your project
The Lightning Rail has been designed to work on both horizontal
and stair rail applications. Check local building code requirements
prior to starting your project. For stair rails, a 6" ball should not be
able to pass through the triangular space formed by the bottom
rail, tread and riser (see fig. 1). Also, the top rail should rise 34" to
38" above the tread nose. For horizontal rails, the top rail typically
needs to rise 36" from the floor of the deck.
Horizontal Rails
Measure the distance between posts and cut the rails to size.
For even spacing between balusters and posts, be sure to cut
equal lengths from both ends of the rails.
Stair Rails
Measure the distance between installed posts to determine the
length of the top and bottom rails. Lay bottom rail on stairs, and
adjust top rail so that the balusters align parallel to the posts to
determine angle and length. Mark the angle and length. Trim the
top and bottom rails to length with the same angle.
Attach the rail by using (4) – 2x4 rail connectors (sold separately)
as shown in fig. 2.
Fasten a support block (sold separately) at the center of the
bottom rail to the deck surface for spans greater than 36".
This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. Consumer assumes all risks and liability associated with the use of this product.
For details on safe handling, go to UFPI.com/ptinfo. Warrantor does not provide any warranty, either express or implied, and shall not be liable for any damages, including consequential damages.
• Carpenter's level
• Carpenter's pencil
• Safety glasses/goggles
• Gloves
Step 1
Step 2
Step 3
©2014 Universal Forest Products, Inc. All rights reserved.
Assembled in the USA with balusters from Mexico. 68956 U.S. Highway 131, White Pigeon, MI 49099 8450_8/15
Railing Brackets (4)
Post
•
Cap
•
•
•
Outside Edge of Stairs
StairsOutline3a1.ai
•
•
34" < Tread Nose to
Top of Rail < 38"
•
•
•
Baluster
•
Less than 6"
Less than 4"
Support Block
Top and
Bottom Rail
fig. 1
fig. 2