Preparation For Operation; Operation And Maintenance - GRAPHITE 58G782 Manual De Instrucciones

EQUIPMENT AND ACCESSORIES
1. Mixer shaft
2. Mixing paddle
3. Transport case
Disconnect the power tool from power supply.
Screw the shaft (5) into the mixer spindle (1) (fig. A).
Screw the mixing paddle (6) to the shaft (5).
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the mixer.
The mixer is equipped with the switch, which protects against accidental starting.
Switching on
Press the switch lock button (4) located on the handle (fig. B).
Press the switch button (3).
Switching off
Release pressure on the switch button (3).
2 GEAR SELECTOR SWITCH
Rotational speed can be changed with the use of two-position gear switch (2) (fig. C). Depending on the
work being carried out, set the gear switch to appropriate position.
Position '1' is for lower speed and greater torque.
After switching to the right, to position '2', the speed is greater and the torque is lower.
To restore lower speed set the switch back to the left position.
Never change the gear switch position under operation of the mixer. It may damage the power tool.
Turn the spindle slightly if the switch position cannot be changed.
ROTATIONAL SPEED CONTROL
Wheel for rotational speed control (7) is located on the mixer handle (fig. D). Control range is from 1 to 6,
the speed can be changed depending on the user's needs when working on either gear.
USE OF THE MIXER
Ensure the power supply voltage is 230 V.
Connect the power tool to the power supply network.
During operation, always hold the mixer firmly (with both hands).
Electronic controller allows for slow start of the mixing (no splash) and slow stop.
By turning the control wheel (7) you can increase or reduce rotational speed of the spindle.
Unplug the power cord from the mains socket before commencing any activities related to
installation, adjustment, repair or maintenance.
Keep the mixer clean.
When using the mixer always check that the ventilation holes are not obstructed and no foreign body
got between internal parts of the power tool.
- 1 pce
- 1 pce
- 1 pce

PREPARATION FOR OPERATION

OPERATION / SETTINGS

OPERATION AND MAINTENANCE

11