Publicidad
Enlaces rápidos
SLB222 analyser by CDR – Short Guide
Short instructions do not replace the complete user's manual.
Analysis systems based on the SLB222 analyser are:
CDR FoodLab ® , CDR WineLab ® , CDR BeerLab ® , CDR CiderLab, CDR PalmOilTester, CDR OxiTester
Incubation Cells
Reading photometric Cells
ON/OFF button
For the installation of the instrument, proceed as follows:
A. Place
the SLB222 analyser
temperature fluctuations or excessive light.
B. Connect the external power adapter to the port at the rear of the instrument using the appropriate power cord to an outlet
between 110V to 230V.
C. Press the ON/OFF button to switch ON the analyser. Press and hold the ON/OFF button for six seconds to switch OFF.
Rear panel
Ethernet port
24V DC electric power port
on a flat surface in an area that it is not exposed to mechanical vibrations or extreme
USB Type-A port
USB Type-B port
MAN504
.rev09
Printer
Touch screen
Publicidad
Manuales relacionados para CDR FOODLAB SLB222
Resumen de contenidos para CDR FOODLAB SLB222
- Página 1 SLB222 analyser by CDR – Short Guide Short instructions do not replace the complete user’s manual. Analysis systems based on the SLB222 analyser are: CDR FoodLab ® , CDR WineLab ® , CDR BeerLab ® , CDR CiderLab, CDR PalmOilTester, CDR OxiTester Printer Incubation Cells...
- Página 2 MAN504 .rev09 D. After powering ON the analyser, the photometer optics will be controlled together with other functional parts and on the screen are shown: and then At the end of the heating process, the Main dialogue is shown: The analyser is now ready to be used.
- Página 3 MAN504 .rev09 How to check if the analyser has the latest software version. We suggest to carry out the check after the first switch-on. 1. Connect the instrument to your PC via the USB-type B cable 2. Find the CDRDRIVE in your PC and open it 3.
- Página 4 CDR SLB222 Installing printing paper Pull up the green lever on the printer to release the black roller and insert the paper under the printer roller. Pull down the green lever to secure the printing roll and turn the green wheel to adjust the paper.
- Página 5 étalonné en phase de fabrication. The device cannot be used with assay samples that have not been specifically L’instrument ne peut être utilisé avec des échantillons n’étant pas fournis par CDR. released by CDR. L’instrument ne travaille pas avec des tests diagnostiques en flux....
- Página 6 Lo strumento non può essere impiegato con saggi diagnostici non rilasciati da CDR. Lo strumento non opera con test diagnostici in flusso....