Southwire M400TP Instrucciones De Uso página 4

Operation
Testing a Data Cable Terminated with RJ45 Connectors
WARNING:
Exposure to voltage can damage the tester. Immediately
disconnect the cable under test if the Voltage warning appears on the display.
Make sure the cable is not connected to any device that can supply voltage
before retesting.
1. Connect one end the cable under test to the RJ45 port on the tester.
2. Detach the remote from the bottom of the tester.
3. Connect the other end of the cable under test to the RJ45 port on the remote.
4. Momentarily press the MODE button.
5. Interpret the results using the Wiring and Display Examples on page 7.
Detachable
Remote
5
Operation
Testing an Installed Data Cable
1. Connect a known good patch cable to the wall port or patch panel
of the cable being tested.
2. Connect the other end of the patch cable to the RJ45 port on the tester.
3. Detach the remote from the bottom of the tester.
4. Connect another known good patch cable to the RJ45 port on the remote.
5. Connect the other end of the patch cable to the wall port or patch panel
at the other end of the cable being tested.
6. Momentarily press the MODE button.
7. Interpret the results of the test using the Wiring and Display Examples
shown on page 7.
Patch Panel
Detachable
Remote
Patch Cable
6