Publicidad
Guided Tour - HT6
2
3
1
1: Audio on-off switch - When set to the "up"
position, audio signal is transmitted. When set to
the "down" position, the audio signal is muted.
Because the carrier signal remains during muting,
no "pop" or "thud" will be heard. Note that turning
this off does not turn off the transmitter power—it is
simply a way to temporarily mute the transmission
of audio signal. If you don't plan on using the HT6
for extended periods, turn off its power by using
the power on-off switch (see photo above).
4
2: Battery level meter
color LEDs indicates relative battery power, indi-
cating whether the installed battery is at low (red),
high (green) strength.
When only the red "low" indicator lights RF perform-
ance is degraded and the battery needs to be replac-
ed.
3: Power on-off switch* - Use this to turn the
HT6 on or off (to conserve battery power, be sure
to leave it off when not in use).
4: Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe
the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type
battery. Although rechargeable Ni-Cad batteries can be used, they do not supply ade-
quate current for more than four hours. WARNING: Do not insert the battery backwards;
doing so can cause severe damage to the HT6 and will void your warranty.
* Be sure to mute the audio signal at your external mixer or amplifier before turning trans-
mitter power on or off, or an audible pop may result.
10
Publicidad
