Safco 2176 Guia De Inicio Rapido página 2

1
Fit the A Hanger to the underside of your computer work
surface ("L" forward for left-side mounting; "R" forward for
right-side mounting). Mark the small hole positions with an awl
or nail, and mount securely with four E Large Screws. Mount
the B Upper Bracket to the Hanger using four F Socket
Screws.
A
F
B
3
Slide the C Lower Bracket into the B Upper Bracket to the
desired height (left-side mounting shown). There are seven
positions available, at 1" spacings, to adjust to CPU heights
from about 15" to 21".
B
C
2176-37MP: 2 of 6; Rev. 1; 2/06
2
Place the G Washer onto the stem of the H Knob, and
insert the Knob stem through the slot in the C Lower
Bracket. Place the I Spacer onto the Knob stem, and
screw the Knob into the threaded hole on the D CPU Stop.
Leave the Knob loose enough for the Stop to slide.
E
"L" OR "R"
4
Peel the backing from the J Round Pads and mount them to
the Upper Bracket as shown. Peel the backing from the K
Rectangular Pads and mount them to the CPU Stop as
shown. Place the CPU into the holder, slide the Stop against
the CPU, and tighten the Knob.
C
I
G
H
J
K
Safco Products Company, New Hope, MN 55428
D