System Requirements - Logic3 Action Pad JP284 Manual Del Usuario

Vibration Driver Installation for PC
(1) Installing the dedicated Vibration Driver (For PC vibration feedback only)
Note: You must install the driver before connecting your Action Pad
1. Turn on your computer and log onto Windows.
2. Insert the driver disk to your selected CD drive. The Set-up screen will pop up automatically.
3. Follow the instructions on screen. Restart your computer if prompted.
4. Plug the Action Pad into a spare USB port on your computer.
5. Installation is completed.
(2) Verifying Installation:
Click "Start" in the lower left corner of your desktop.
1.
Click "Setting" and then "Control Panel"
2.
Now Double Click the "Game Controllers" icon (different Windows platforms may have different names).
3.
You should see the driver named "PC Twin Shock" under Controller Tab with an "OK" status.
Select "PC Twin Shock" and then click the properties tab, you will now enter the "Driver Test" screen.
4.
Go to the "Function Test" Tab and test all of the axes/ buttons/switches on the Test screen by activating
5.
the corresponding axes/buttons/switches of the pad.
Go to the "Vibration Test" screen by clicking the "Vibration Test" Tab on the top part of the screen.
6.
Different kinds of vibration effects can be tested.
7. Your installation is successful if you can go through all the above points without any problems.
Click "OK" to exit.
8.

System Requirements

PC with a USB port
Windows 98SE / ME / 2000 / XP / Vista / Windows 7 (32 & 64 bit)
Over 200MB free hard disc space
CD ROM driver
32MB or higher memory
Support DirectX VGA card
PC platform: Pentium (R) - 1.8GHz/ RAM: 256M
Should you have any setup problems with the Action Pad (JP284) please contact our Technical Support Hotline
on +44 (01923)471000 – National/International call rates apply or Email support@logic3.com - Spare parts
are available for some models at our website www.logic3.com