Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
RUS0238-CS01-3
2
RUS0238-CS01-2
3
62RUS0236I101
4
RUS0238-CS04-1
5
RUS0238-CS11-1
6
17C40A0710001YX
7
17C40A0719001YX
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Step 1:
Insert the right and left arms (#1 and #2) into the cross
braces (#3) on both sides. Fasten them together by using
bolts (#6), washers (#9), and plastic nuts (#10). Keep the
bolts loose. See Figure 1.
Note:
The labels marked "L" and "R" on arms (#1 and #2) should
coincide with Figure 1 to ensure proper assembly.
Use the correct bolts as indicated. Do not tighten any of the bolts until the glider is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
!
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
!
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
RUS0238
PART
Q'TY
RIGHT ARM
LEFT ARM
CROSS BRACE
BOTTOM FRAME
SEAT ASSEMBLY
BOLT M6*30
BOLT M6*55
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO STORE!
STOP
PAGE 1 OF 3
8
17C40A0725091YX
9
1
17FA05040301-YX
10
1
18000C23001
2
11
17KAA0101----Y4
12
1
17KAB1101----Y4
1
13
61R0238X00001BA
4
14
61R0238X50001BA
4
15
61R0238Y00001BA
FIGURE 1
1
R
Arm
Assembly
1
6
BOLT M6*75
WASHER d6.5*D13*1.0
PLASTIC NUT M6*P1.0
HEX. KEY WRENCH 4MM
NUT WRENCH 10 & 13MM
LEFT BACK CUSHION
RIGHT BACK CUSHION
SEAT CUSHION
3
3
2
3
3
10
9
#6 BOLT M6*30
COURTYARD CREATIONS INC.
4
24
12
1
1
1
1
2
2
L
30

Publicidad

loading

Resumen de contenidos para Courtyard Creations RUS0238

  • Página 1 Children should always be under direct adult supervision while using this product. Retain these assembly instructions for future reference. Quote the following FQC NO. when contacting the service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 DO NOT RETURN TO STORE! STOP COURTYARD CREATIONS INC. PAGE 1 OF 3...
  • Página 2 FIGURE 2 FIGURE 3 FRONT HIGHER TUBE #7 BOLT M6*55 Step 2: Step 3: Place the arm assembly onto the bottom frame (#4). Make Fasten the swing bars on the arm assembly to the bottom sure that the higher tube on the bottom frame (#4) is facing frame (#4) by using bolts (#7), washers (#9), and plastic nuts towards the front of the glider.
  • Página 3 Warranty • This product is covered by Courtyard Creations Inc.'s one–year limited warranty. • Proof of purchase (dated register receipt) is required for warranty claims. • It remains the customer’s responsibility for freight and packing charges to and from the service center.
  • Página 4: Instrucciones De Armado

    Cuando se comunique con el centro de servicio, proporcione siempre el siguiente código de control de calidad (FQC, por sus siglas en inglés). NÚMERO GRATUITO DEL CENTRO DE SERVICIO TEL: 1-877-539-7436 FAX: 1-877-539-7439 ¡NO DEVUELVA ESTE PRODUCTO A LA TIENDA! ALTO COURTYARD CREATIONS INC. PÁGINA 1 DE 3...
  • Página 5 FIGURA 2 FIGURA 3 FRENTE TUBO SUPERIOR #7 TORNILLO M6*55 Paso 2: Paso 3: Sujete las barras deslizadoras del armazón con brazos al Coloque el armazón con brazos en el marco inferior (#4). marco inferior (#4) con ayuda de los tornillos (#7), las Asegúrese de que el tubo superior del marco inferior (#4) dé...
  • Página 6: Lea Estas Instrucciones Completamente Antes De Empezar El Armado

    Garantía • Este producto está cubierto por una garantía limitada de un año con Courtyard Creations Inc. • Para cualquier reclamación de la garantía es necesario presentar el comprobante de compra (recibo de caja registradora con fecha). • El cliente será responsable por los cargos de empaque y envío a y desde el centro de servicio.