oneConcept Arielle Deluxe Manual Del Usuario página 13

Fasten the wall bracket with suitable fasteners. Make sure that the screw
is inserted as straight as possible so that the flat head of the screw is within
the countersink area, as shown in Figure 4. If it protrudes outwards, it may
interfere with the disassembly of the backrest panels.
Right
Flat head mounted
straight into the hole
(5) After mounting, use the spirit level shown in Figure 1 (b) to ensure that the
seat is straight. Then determine the position of the top hole on the right
side of the wall bracket.
Important: Ensure that the distance between the wall brackets allows easy
movement of the backrest panels.
(6) First repeat steps 2 to 4 for the upper hole on the right side of the wall
bracket and make sure it is level.
(7) Repeat steps 2 to 4 and the remaining holes.
Note: Perform a final suit and inspection of all fasteners. Test the
installation by pressing the seat down or sitting on it.
(8) Once all screws are in place, slide the backrest plates onto the wall
bracket. Make sure they are seated correctly.
(4)
Wrong
Flat head mounted
at an angle in the hole
EN
13