AMAZON COMMERCIAL B07RV85KCV Guía De Bienvenida página 7

Step 4:
INSTALL STRIKER PLATE
Close door to mark horizontal center line of strike.
•
Measure one half of door thickness from door stop to mark
•
vertical center line of strike. Drill 1" (25.4mm) hole, 1/2" (12.7mm)
deep at intersection of horizontal and vertical center lines.
Chisel out door jamb 1/16" (1.6 mm) deep or until strike plate
•
sits flush with door jamb.
Tighten screws securely.
•
A
C
B
D
7