Assembly Step; Assemble The Rail And Install The Trolley - Sears CRAFTSMAN 139.53939D Manual Del Propietário

ASSEMBLY STEP 1

Assemble the Rail and Install the Trolley

To avoid installation difficulties, do not run the
garage door opener until instructed to do so.
The front rail has a cut out "window" at the door end (see
illustration). The hole above this window is larger on
the top of the rail than on the bottom. A smaller hole
3-1/2" (8.9 cm) away is close to the rail edge. Rotate the
back rail so it has a similar hole close to the opposite
edge, about 4-3/4" (12 cm) from the far end.
1. Remove the straight door arm and hanging bracket
packaged inside the front rail and set aside for
Installation Steps 5 and 12. NOTE: To prevent
INJURY while unpacking the rail carefully remove the
straight door arm stored within the rail section.
2. Align the rail sections on a flat surface as shown and
slide the tapered ends into the larger ones. Tabs along
the side will lock into place.
Screwdriver
Window
Cut-Out
Idler
Pulley
Hole
KEEP LARGER
HOLE ON TOP
FRONT RAIL
(TOP)
Tapered
End
Tabs
Front Rail
(TO DOOR)
To prevent INJURY from pinching, keep hands and fingers
away from the joints while assembling the rail.
3. Place the motor unit on packing material to protect the
cover, and rest the back end of the rail on top. For
convenience, put a support under the front end of
the rail.
4. As a temporary stop, insert a screwdriver into the hole
10" (25 cm) from the front end of the rail, as shown.
5. Check to be sure there are 4 plastic wear pads inside
the inner trolley. If they became loose during shipping,
check all packing material. Snap them back into
position as shown.
6. Slide the trolley assembly along the rail from the back
end to the screwdriver.
Tapered
End
Tapered
End
Outer Trolley
Inner Trolley
Wear Pads
8
Trolley
Tapered
End
Back Rails
(TO MOTOR UNIT)