General Safety Regulations - MAXTOOLS TJA1350 Manual Del Usuario

FOREWORD
We thank you for buying this qualified product. Before using this product, carefully read these
instructions and become acquainted with the safety symbols.

GENERAL SAFETY REGULATIONS

ALSO SEE SAFETY SYMBOLS ON PRODUCTS LABEL
• This product is designed and made only for lifting vehicles.
• Never lift loads on sloping, uneven or soft ground.
• Before starting lifting, it is necessary to block the vehicle by placing two wedges by the
wheels, as shown on the label.
• Make sure that the vehicle lifting point suggested by the car manufacturer is stable and
properly centered on the jack saddle.
• After lifting the load it is absolutely essential to rest it on car stands.
USE
ALSO SEE SAFETY SYMBOLS ON THE PRODUCTS LABEL
• ATTENTION: Before first use unscrew the screw indicated with arrow in the figure 1
on page 8 of 1 or 2 turns (not more than). In case of trolley handling close the screw
again.
• Insert the handlebar into the handle fork of the jack.
• Check if the pressure release valve is closed (turn clockwise).
• Make sure that the vehicle lifting point suggested by the car manufacturer is stable and
properly centered on the jack saddle.
• Start lifting and do not exceed the rated load.
• After lifting the load, always place car stands.
• To lower the jack, remove the car stands and slowly open the pressure release valve (turn
counter clockwise).
MAINTENANCE
Keep the jack at minimum height when not in use. Make sure that the pressure release valve
is closed.
Keep the jack clean and check the oil level at least twice a year.
GUARANTEE
This product is fully guaranteed against manufacturing defects for a period of 36 months from
the date of purchase.
If your product proves faulty during the guarantee period, it should be returned to the place of
purchase together with the original receipt.
English
3