Wahl 56535-400 Instrucciones Especiales Para El Uso

Special Instructions for Use of
Hot-Cold Massage Therapy
DEEP HEAT ATTACHMENT
NOTE: Only the deep heat attachment can be used for the
heat function.
Massager
Stem
To insert Deep Heat Attachment, simply align the special
track bar with the grooved section in the massager stem
Deep Heat
(see diagram), then press firmly onto stem. To detach, use
Attachment
thumb and two fingers and pull away from stem.
When Deep Heat Attachment is correctly aligned and
pushed on the stem, the electrical heat element is automatically connected. Test the surface for a
comfortable temperature. The massager will heat to the desired level within four minutes.
NOTE: When using heat, always check temperature before placing massager against skin. Every
person reacts differently to certain temperatures. We suggest the following before use — check
temperature by lightly touching with fingertips the silver heat plate on the massager. If
uncomfortable to your touch, reduce temperature by (1) rubbing massaging surface on soft cloth
or (2) turning off unit for a short period before applying to your skin. Keep the massager moving
constantly any time heat is on. Never use heat on swollen or inflamed areas, or on skin
eruptions.
NEVER use the heat applicator if the plastic housing is cracked or broken, or if the metal plate is
loose, bent or lifted.
CAUTION: The two holes in the stem of the massager are like an electrical plug — electrical
power is transmitted through them. NEVER allow water near the stem, and never insert anything
into the holes.
COLD GEL ATTACHMENT
**DO NOT MICROWAVE. FOR COLD THERAPY
USE ONLY**
Place gel pack in the freezer. After 1-2 hours, the gel pack
will reach the desired cold temperature. It is ideal to allow
the gel pack to freeze overnight for optimal cold therapy.
Cold will last for 20-30 minutes then remain cool. If the
gel pack is uncomfortable during use, discontinue use
immediately.
Part No. 56535-400
Printed in China