Cleaning, Care & Maintenance; Manual Defrost; Troubleshooting - NISBETS ESSENTIALS DA536 Manual De Instrucciones

Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm water only.
• Always wipe dry after cleaning.

Manual defrost

Nisbets Essentials recommend defrosting the appliance when any frost build up inside the freezer reaches
5mm thick.
1. Turn the freezer off and disconnect it from the power supply.
2. Remove food and shelving basket.
3. Put a water container underneath the drain hole at the left lower part of the front. Then unscrew the 2
drain hole covers (one inside the compartment; the other on the front housing).
4. Let the inside frost melt naturally. Wipe off any residue water.
5. When defrost done, put back the drain hole covers.

Troubleshooting

If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to
the Helpline or your Nisbets Essentials dealer.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
The appliance Too much ice on the evaporator
turns on, but the
Condenser blocked with dust
temperature is too
Lid not shut properly
high/low
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Ambient temperature is too high
Appliance is overloaded
The appliance is Loose nut/screw
unusually loud
The appliance has not been installed in
a level or stable position
Difficult to open the Vacuum created by pressure
lid differences
DA536_ML_A5_v3_20210826.indb 5 DA536_ML_A5_v3_20210826.indb 5
Probable Cause
Check the unit is plugged in correctly and
switched on
Call Nisbets Essentials agent or qualified
Technician
Replace the fuse
Check power supply
Defrost the appliance
Clean the Condenser
Check lid is shut and seals are not damaged
Move the freezer to a more suitable location
Increase ventilation or move appliance to a
cooler position
Reduce the amount of food stored in the
appliance
Check and tighten all nuts and screws
Check installation position and change if
necessary
Allow 20-30 seconds for pressure to
equalise
UK
Solution
5
2021/8/26 13:14 2021/8/26 13:14