Device Elements; Initial Operation - SURTECO Dollken Profiles HKP 2.0 E Instrucciones De Servicio

GB
2.3

Device elements

3 Operation
Please always pay attention to the safety information in chapter 1.
3.1 Safety in handling
Attention!
Observe the following instructions to prevent the risk of injuries and
damage to the device:
1. Never lay down the device on its side in its hot operative state. This
could cause the unchecked leakage of adhesive. Risk of burns/dama-
ge to the device!
2. Never remove the adhesive residues from the melting chamber by
force (e.g. with a scraper or screwdriver). This could damage the inte-
rior lining of the melting chamber.
3. Never loosen „frozen" hot-melt adhesive candles by force (e.g. with
tongs).
4. Use the device only after it has completely heated up, indicated by the
green display.
5. Observe the instructions for Döllken hot-melt adhesive (processing
error avoidance).
6. Never extract the old adhesive candle from the device, since this can
damage the transport mechanism!
3.2

Initial operation

1. Insert the mains plug into a power socket with protective earth.
2. Switch the device on using the on/off switch (6) - on the display (5) at
right.
The display (5) lights up in blue.
The device starts to warm up immediately.
To protect the device, the settings (including heating and drive) are
disabled, and the setting keys on the display have no function.
3. When the Display is green, the pistol is ready to operate.
4. If the adhesive candle has already been inserted, liquid adhesive can
come out of the nozzle. You should place the device on a suitable surface
to protect against this. Allow the device to heat up for 10 minutes.
1 Hook nozzle
2 Stand
3 Feed switch
4 Delivery rate switch
5 Display buttons blocked - device protection
6 On/Off switch
7 Power cable
8 LED slot for glue sticks
11
Operation