Binding With Strip - Fastbind ELITE Manual De Instrucciones

BINDING WITH STRIP

Section 7
BINDING WITH STRIP
Check List & Preparations
Binding Procedure
7.1. LOADING STRIP AND PAPERS
7.1.1
7.1.2
a)
www.maping.com
Before you begin, ensure that
• Τhere is glue in the applicator reservoir (Fastbind Hot-Melt)
•
Machine has warmed up at least
• Τhat softcover nipping plate is attached (marked with "S")
• Τhe turntable is in normal position.
• Τhe paper guide is in place (S or H-model)
PREPARATIONS:
Fold one A4 or letter size paper sharply along the long side so that
a.
the folding line divides the paper in approximately ratio
Open the clamp and place the folded paper on positioning
deck. Align the paper against paperguide.
Take a strip and make a sharp folding line on one side of the
strip.
a)
b)
b)
1 - 14
20 min
Folded strip.
Place the folded strip on paper. Note strip's alignment:
short folded part against the turntable while the long
tail comes towards and on top of the nipping tool.
30_ :_ 70%
REV. d5 Elite Multilang
© 2004.12 Maping Co