widmer Wi-Oil 1500-7 Manual De Instrucciones página 42

EEI English
Intended Use
This appliance provides heating or additional heating for dry
'ooms in private residences.
The rooms must haveafloorarea of5 m
The rooms must be ventilated. The appliance is
intended for domestic use and in similar areas of
application.
t may only be used in the manner described in this user
manual. The appliance may not be used for commercia
ourposes.
Any other use is deemed not as intended and may lead
damage to property or even to personal injury. The
manufacturer assumes no liability for damage as a result of
use other than the intended use.
Supplied Parts
1 Heater
2 Castor housinc 4
Castors
2 Plate, U-shapec
2 Wing nuts
Unpacking the Appliance
1. Remove the appliance from the packaging.
2. Remove all packaging material such as plastic wrap, flier
material, cable ties and cardboard packaging.
3. Check that all supplied parts are included in the box.
1 NOTE:
There may still be dust or production residues on the ap-
pliance. We recommend that you clean your appliance as
described under "cleaning".
Description of Parts
1 Display
2 MODE button
3 °C/°F button
4 —button
5 (!) button
6 + button
7 Handle
3 Power switch
9 Power corc
10 Castor housinc
Assembling the Rollers
CAUTION:
f\
Before the device is used for the frst time the rollers have
to be attached.
D
lease also see our illustration!
•
1 NOTE:
2
It is best to place a blanket underneath so that the housing is
or more.
not damaged.
•
•
•
tc
•
Instructions
•
Electrical connection
•
•
•
Connected Wattage
The three power levels of the devices are as follows:
With this connected load a separate supply line protected by
a 16 A household circuit breaker is recommended.
/\ CAUTION Overload:
•
•
•
Safety Switch
Your radiator has a safety switch which turns off the electricity
as soon as the device falls over. The safety switch prevents
dangerous situations caused by overheating.
/\ CAUTION:
Always place the device in an upright position in order that it
is stable and in order to prevent malfunctions.
AWARNING:
The appliance may still remain hot after it has toppled over.
Wait until it has cooled down.
1 NOTE:
Switch the appliance on again using the(|)button.
Turn the radiator upside down.
Push the 4 castors onto the pinsof the castor housing.
Place the U-shaped brackets between the first and
se-cond and between the last and penultimate fn.
Insert the endsofthe brackets through the holes in the
'oller carriers.
Attach the brackets with the wing nuts.
Unwind the cable completely.
Make sure that the ironvoltage(see name plate) and the
ne voltage match.
Switch the power switch to 0.
Only connect the mains plug toa properly
earthed socket 220-240 V~, 50 Hz.
RA 5587
RA 5588
RA 5589
If you use extension leads, these should have a cable
cross-section of at least 1.5 mm
Do not use any multiple sockets, as this device is too
powerful.
Do not connect other high power appliancesto the
same circuit.
installec
= 1500 W
= 2000 W
= 2500 W
2
.