Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL
TRAINING
POINTER
17. Install Top Bearing and press into the tub.
18. Place Tub Press Tool Assembly (without the Bottom
Bearing Press, Thrust Bearing, and Bottom Press Nut)
over new Top Bearing.
NOTE: Ensure LOCKING BAR of Tub Press Tool Assembly
is located in sump area. See Figure 12.
19. Tip washer back on hoses.
20. Install onto Press Rod; new Spacer Tube, new
Bottom Bearing Washer, and new Bottom Bearing. Then
install tool parts: Bottom Bearing Press, Thrust Bearing,
and Bottom Press Nut. See Figure 13.
BOTTOM
BEARING
BOTTOM
BEARING
PRESS
PRESS ROD
21. Tighten Bottom Press Nut until bearings bottom out.
Then back the Bottom Press Nut off and remove. See
Figure 14.
NOTE: Final position of bottom bearing will extend from
bottom of tub by 1/8" to 3/16" (3 to 5mm).
Page 4
® Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn‐Air, U.S.A., or Maytag Properties, LLC or its related companies.
For Immediate Attention of Your Service Department
Technical Training Pointer #: W10470122A
Release Date: November, 2012
Remove and Replace W10470122 Dated 11/11
Figure 12
SPACER TUBE
BOTTOM
BEARING
WASHER
THRUST
BEARING
PRESS NUT
Figure 13
®MAGIC CHEF is a registered trademark of CNA International, used under license. © 2012 All rights reserved.
22. Tip washer forward off the hoses and remove the
Tub Press Tool Assembly.
23. Install new Drive Shaft (make sure wear sleeve is
bottomed out on Top Bearing). See Figure 15.
NOTE: If necessary, tap shaft with hammer to install.
24. Tip washer back onto hoses. Install new Shaft Nut
and tighten. See Figure 16.
25. Reconnect wiring harness to stator.
26. Reinstall stator and shield. Check for proper location.
27. Reinstall rotor.
28. Tip washer forward off the hoses.
Laundry Products
Figure 14
WEAR SLEEVE
Figure 15
SHAFT NUT
Figure 16
Publicidad
