Installation; Selecting The Lens - Honeywell L Serie Manual De Instrucciones

Installation

Selecting the Lens

Vari-focal Auto Iris lenses (Direct Drive or Video Drive) are
connected to the camera via a 4-pin square socket located
at the side of the camera.
1. Set the VSD/DC switch on the rear of the camera.
For Video Drive lens, set the switch to VSD.
For Direct Drive lens, set the switch to DC.
Low Voltage model shown
(HCD484L, HCD484LX)
UP
MENU
+ -
DC 12V
AC 24V
2. Set the EE MODE to ALC MODE on the OSD menu
(see ALC
Auto iris lens with amplifier: Set the VSD LENS on the
OSD menu.
Auto iris lens with no amplifier: Set the DC LENS on the
OSD menu. Adjust to the LEVEL carefully to avoid
hunting.
Rev 2
VIDEO
REMOTE
+
DOWN
VSD
PWR
DC
GND
MODE).
VSD = Auto iris lens with a built-in
amplifier (video-type lens)
DC = Auto iris lens with no amplifier
(DC-type lens)
4 G-113079-002
02/07