Classic Accessories veranda 71952 Instrucciones

Instructions: Standup Patio Heater Cover
CAUTION!
Let your heater cool before you put your cover on.
Installation
Check your standup heater to make sure there are no
sharp objects or corners
that could stress your cover
as you pull it on.
If your standup heater has
a center table, lower the
table to the lowest position
close to the base before
installing your cover.
Completely unzip your
cover all the way from the
top to the bottom and
around the top.
Undo the rip-and-grip
closure at the bottom of
your cover.
Using a stepladder,
carefully slip your cover
over the top of the heater
and zip it closed around
the top. Wrap the cover
around the body of the
heater, starting at the
heater base. Zip your
cover up to the top of your
heater. Close the rip-and-
grip closure at the bottom
of your heater.
Cleaning and Care
This cover will fit standup patio
Clean your cover with a soft brush and luke-warm water.
heaters with round or square bases.
DO NOT USE SOAP as it may remove the protective
coatings added by the factory. Air dry.
Storage
To avoid any possibility of mildew be sure your cover is
completely dry before you store it in an enclosed area
for a long period.
Classic Accessories, Inc.
Kent, WA USA 98032
classicaccessories.com
©2010
71952-LC
10cH55_11288