LaserLiner StarFinder Plus Manual De Instrucciones página 6

Read the operating instructions and the enclosed brochure „Guarantee and
!
additional notices" completely. Follow the instructions they contain. Safely
keep these documents for future reference.
Function / Application
Multiple integrated sensors make StarFinder Plus by Laserliner a highly efficient detecting
device for locating wall beams and joists in drywall structures and finding live lines. The
StarFinder Plus is equipped with an LC display with user guide, ensuring easy and reliable
operation. Acoustic and optical detection signals to locate objects facilitates handling and
ensures a high level of functional reliability.
1
2
3
4
5
1 Insert battery
Open the battery compart-
ment on the housing's
rear side and insert a 9V
battery. Correct polarity
must be observed.
3 Symbols
Red = Live wire warning
AC-SCAN mode
Green = live wire is nearby
Red = live wire found
STUD-SCAN mode
Green/Red: object is nearby
Green: object found
4 Calibration
Auto-Calibration
The automatic calibration is performed in AC-SCAN measure-
ment immediately when the device is switched on and when the
measuring mode is switched. During calibration, the display shows
„CAL". Do not move the device during this process. Once „CAL
OK" appears on the display, tracing can be started.
Manual calibration
Pressing the CAL button (5) manually calibrates the device. This
allows measurements to be restarted and objects to be isolated
more precisely.
Maximum sensitivity is achieved when the device is held in the air
while calibrating. This can be useful for AC-SCAN measurements.
06
GB
1 Maximum display
2 Live wire warning
3 LC display
4 ON / OFF
Switching measuring mode (MODE)
5 Manual calibration (CAL)
Always switch off the power supply
!
when working in STUD-SCAN mode
in the vicinity of electric conductors.
2 Operation
Switch on: Briefly press the
On/Off button (4).
Switch off: Keep the On/Off
button (4) pressed for 2 seconds.
AutoShutOff: The device will
automatically switch itself off
about 30 seconds after the last
measurement.
line, object is nearby
line, object found