Assembly And Use; Preparing For Operation; Reset Heater - Four Seasons FS200 Manual De Instrucciones

22

ASSEMBLY AND USE

en

PREPARING FOR OPERATION

Unplug the Four Seasons
tank with water.
1. Open the packing box and take out the Four Sea-
sons unit.
™
2. Turn the unit upright for operation.
3. To remove the humidifier wick frame, press the
release tab and pivot the frame outwards and then
lift it out of the unit. See Figure 1.
You must remove the wick frame before you can
remove the tank.
4. Remove the tank by sliding it out of the unit (see
Figure 2).
5. Fill the water tank with clean water to maximum
water level marking on tank.
Do not overfill the tank. Use extreme caution to
ensure that water is poured only into the water
tank and that the rest of the unit stays dry. Never
plug in the unit if it gets wet.
6. After filling, put the tank back into the main body
and replace the humidifier wick frame.

RESET HEATER

unit prior to filling the This heater is equipped with a temperature limiting
™
thermostat. If the unit should sense an overheat
condition, the element will stop heating. It can
only resume operation when user manual reset
the unit.
Unplug the unit and wait 10 minutes for the unit to cool
down, then plug unit back and follow the "Using the
Four Seasons " instruction described in this manual.
™
FIGURE 1 FIGURE 2