ASROCK FM2A88M Pro3+ Manual Del Usuario página 16

2.6 Onboard Headers and Connectors
Serial ATA3 Connectors
(SATA_1: see p.2, No. 16)
(SATA_2: see p.2, No. 15)
(SATA_3: see p.2, No. 14)
(SATA_4: see p.2, No. 13)
(SATA_5: see p.2, No. 12)
(SATA_6: see p.2, No. 11)
(SATA_7: see p.2, No. 9)
(SATA_8: see p.2, No. 8)
USB 2.0 Headers
(9-pin USB_6_7)
(see p.2 No. 18)
(9-pin USB_8_9)
(see p.2 No. 19)
USB 3.0 Header
(19-pin USB_10_11)
(see p.2, No. 20)
16
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
USB_PWR
P-
P+
GND
1
GND
P+
P-
USB_PWR
IntA_P_D-
GND
IntA_P_SSTX+
IntA_P_SSTX-
GND
IntA_P_SSRX+
IntA_P_SSRX-
Vbus
Vbus
IntA_P_SSRX-
IntA_P_SSRX+
GND
IntA_P_SSTX-
IntA_P_SSTX+
These eight Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Besides four default USB 2.0
ports on the I/O panel, there
DUMMY are two USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
Besides two default USB 3.0
ID
IntA_P_D+
ports on the I/O panel, there is
one USB 3.0 header on this
motherboard. This USB 3.0
header can support two USB 3.0
1
ports.
GND
IntA_P_D-
IntA_P_D+