Cosatto 3SIXTI2 Manual De Instrucciones página 4

8 attaching the tray
Attach the tray (2) by sliding it down the tracks on the arm of the chair, pull out the handles (a)
simultaneously and lock it into one of the three positions (b, c & d) to best suit your child.
WARNING: The tray is not designed to hold the child into the chair. The child
should be secured in the highchair at all times by the harness.
CAUTION: When the tray is in the required position pull it forward to ensure
that it is secured.
9 reclining the seat
To operate, squeeze the recline handle and move the seat until it locks into one of the three positions.
WARNING: Before placing the child into the seat, make sure it is properly
secured.
WARNING: Make sure the metal clip is locked into position.
WARNING: Never recline seat whilst the child is seated in high chair.
10 seat orientation
The seat can spin to 6 orientations simply twist the seat to the required orientation until it
clicks into place.
11 adjusting the seat height
a. To raise the seat height press air control pedal, the chair will raise to its maximum position.
b. To lower the seat height press air control pedal whilst pushing down in the middle of
seat release air control pedal before letting go of seat.
CAUTION: Only press down in the middle of the seat to avoid the
highchair from tipping.
WARNING: Never adjust the seat height when child is in the highchair.
Note: the air control pedal maybe stiff during the first few operations.
12 detaching the vertical leg from base
The vertical leg can be detached from base for storage purposes.
Note: It is recommended to lower the seat to its lowest position prior to the detachment
in order to achieve maximum compactness for storage and reduce the risk of injury while
dismantling the product.
1. Place the highchair on its side, pull the trigger (a) underneath the base to release the
vertical leg from the base unit.
2. Pull the two assemblies apart slowly until they are fully detached.
13 transporting the highchair
Wheel located at the rear underside of the highchair are used to aid the transportation of
the highchair.
While standing in front of the highchair, lift the highchair by its seat unit until all friction
pads on the front of the highchair are off the floor then the highchair can be pull along
the ground.