Adidas ZNE 01 Manual Del Usuario página 2

0:02 USB-C
TOUCH CONTROL
CHARGING CASE
ENGLISH
GETTING STARTED
• Open the charging case.
• Press and hold the button on the bottom of the case until the
LED turns to a slow blue pulse.
• Select adidas Z.N.E. 01 from your sound device's Bluetooth
1. TOUCH CONTROLS
Touch the left or right earbud to control audio and phone calls.
‫ 1 ܟ‬touch to play/pause or receive/end a call
‫ 2 ܟ‬touches to skip forward or reject a call
‫ 3 ܟ‬touches to skip backward
2. CHARGING THE EARBUDS
Put your earbuds back in the case and close the lid to turn
them off and begin charging.
3. CHARGING THE CASE
Use a wireless charger or plug the case into a USB power
source to charge it. The case is fully charged when the front-
facing LED is steady green.
To charge the case using a wireless charger, follow the
instruction below.
1. Place the charging case with its back flat against the wireless
charging pad.
2. Make sure that the front LED lights up to indicate that the
0:02 USB-C
case is charging.
3. Once the LED light has turned steady green the case is fully
charged.
4. LED INDICATOR
THE FULL MANUAL IS AVAILABLE AT ADIDASHEADPHONES.COM
The LED shows the case battery charge, from red through
yellow to green (0–100%). It pulses blue while in Bluetooth
pairing mode.
5. PAIRING A NEW DEVICE
adidas Z.N.E. 01 remembers up to 6 previously paired devices
and will try to reconnect if not connected, starting with the
last connected device.
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the button on the bottom of the case until the
LED turns to a slow blue pulse.
3. Select adidas Z.N.E. 01 from your sound device's Bluetooth list.
Note: The earbuds can be connected with one sound device
at a time. Make sure to disconnect from the current device
before reconnecting with a different device.
6. ADJUSTING THE EARBUD FIT
The earbuds silicone sleeve can be removed for a looser fit.
To reatach the sleeve, simply pull the silicone sleeve over
the earbud.
list.
® Note: Make sure the holes in the sleeve are aligned with the
sensors and ports on the earbud.
7. RESETTING THE EARBUDS
If your earbuds become erratic or unresponsive, follow the
instructions below.
1. Place the earbuds in the case and close the lid to restart the
earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will
need to be paired again.
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the Bluetooth pairing button for 10 seconds, until
the LED turns purple, to reset the earbuds to factory settings.
3. Remove of adidas Z.N.E. 01 from your sound device's
Bluetooth list before pairing again.
If the problem persists, perform a hardware reset.
Note: This will delete all user settings and the earbuds will
need to be paired again.
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the Bluetooth pairing button for 15 seconds to
reset the earbuds.
3. Remove adidas Z.N.E. 01 from your sound device's Bluetooth
list before pairing again.