Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Please read and save these instructions
PACKAGE CONTENTS
Assembly and Installation
q If the solar panel is covered by a protective film, remove it before using
the product. Remove the pull-tab from the battery door. Place the solar
light in a location where it can receive a full 8 hours of sunlight to allow
the rechargeable battery/batteries to reach maximum capacity.
1
Attaching and installing the light
q Attach the spike (D) to the post (C) by pressing them together and press
the post into the bottom of the cage base (B).
q Install the bulb on the top cap (A) by turning it clockwise to lock on
the base.
q Install the top cap (A) by turning it clockwise on top of the cage (B).
Pull-tab
B
ATTENTION
SPIKE
IS INSERTED
IN POST
D
2
Installation tips
q If the soil is of a loose, sandy or organic type, grasp the post with both
hands near the spike and firmly push into the ground.
q If the soil is hard, pour some water onto the ground to soften it.
q If the soil is stony, soften the ground with a rake or shovel and remove
large rocks. Dig a small hole, insert the fixture spike, replace the soil and
tap down.
q Never push the fixture into the ground by the fixture head.
WARNING: When planting the spike ensure that there are no underground utility
lines or pipes.
A
B
C
D
A
Bulb
C
ATTENTION
LE PIQUET
EST INSÉRÉ
DANS LE POTEAU
D
Part
Description
A
Top cap
B
Cage
Post
C
D
Spike
3
Battery replacement
CAUTION: The light element is fragile. Please be careful not to touch when
removing the bulb to change the battery.
NOTE: This operation should be done in the morning on a sunny day. This will allow
the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach
maximum capacity.
q Remove the top cap (A) by turning it counterclockwise.
q Remove the bulb by turning it counterclockwise.
q Remove the battery cover.
q Remove the old battery and replace with 1 new AA NiMh
rechargeable battery of same or greater mAh.
(USE RECHARGEABLE BATTERIES ONLY).
Note : Clean the battery contacts and those of the device prior to battery installation.
q Be sure to insert the battery in proper direction.
q Replace the battery cover.
q Replace the bulb by turning it clokwise.
q Replace the top cap by turning clockwise.
Battery
Battery cover
Item #1002 629 570
Model #HD28583
Use and Care Guide
SOLAR PATHLIGHT
Quantity
6
6
6
6
A
LED
Publicidad
Manuales relacionados para HAMPTON BAY HD28583
Resumen de contenidos para HAMPTON BAY HD28583
- Página 1 Item #1002 629 570 Model #HD28583 Use and Care Guide SOLAR PATHLIGHT Please read and save these instructions PACKAGE CONTENTS Part Description Quantity Top cap Cage Post Spike Assembly and Installation q If the solar panel is covered by a protective film, remove it before using Battery replacement the product.
- Página 2 Care and Cleaning q Clean the fixture with a soft, dry cloth. q Do not use any cleaners with chemicals, solvents or harsh abrasives. Troubleshooting If the light does not turn on at dusk after 8 hours of charging : q Ensure that the solar light is in a bright sunny location and not in a shady area during the day.
- Página 3 Núm. de artículo 1002 629 570 Núm. de modelo HD28583 Guía de uso y cuidado LÁMPARA DE PASILLO SOLAR Por favor, lea y guarde estas instrucciones CONTENIDO DEL PAQUETE Pieza Descripción Cantidad Tapa de la cubierta Jaula Poste Estaca Ensamblaje e instalación q Si el panel solar está...
- Página 4 Cuidado y limpieza q Limpie la lámpara con un paño suave y seco. q No use ningún limpiador con químicos, solventes o abrasivos ásperos. Resolución de fallas Si la lámpara no enciende al anochecer después de 8 horas de carga: q Asegúrese de que la lámpara solar se encuentre en un lugar bajo sol brillante y no en un área con sombra durante el día.