Installing Components - Symantec S450 Serie Guia Del Usuario

Installing Components

Component replacement for the appliance is documented in the following sections.
•
"Installing Drives" on page 21
•
"Installing Fans" on page 22
•
"Installing Power Supplies" on page 24
Installing Drives
The appliance can be equipped with up to eight storage drives. The drives are hot-swappable. Depending
on the appliance model and its configuration, some drive bays might be populated with empty drive car-
riers.
To install a replacement drive:
1 Open the bezel by rotating it down.
2 Locate the drive you want to replace by device number using the appliance software or by verifying the
drive status LEDs (see "Bezel/Storage" on page 17).
3 Click the eject button of the drive you want to replace. The carrier latch opens and the drive ejects.
Remove the carrier.
4 Insert the replacement drive, with its carrier latch open, in the empty drive bay. Make sure the drive is
oriented with the eject button to the left. Insert the drive all the way by pushing the carrier body until
it clicks into place. Close the carrier latch.
5 Verify the drive's LED turns solid green after it boots.
6 Close the bezel.
Chapter 3 English Instructions 21