Team International TEAM BL 6 Manual De Instrucciones página 8

Fax +32 2 359 95 50
The appliance is designed for the preparation of small quantities of food, which have to
be consumed rather quickly. It is not designed for the preparation of large quantities at
once.
Do not touch the blades while the appliance is operating and do not try to block their
movement in any way.
Do not use the appliance without any food in it.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
BE CAREFUL!
1) Your appliance is fitted with a security device on the pouring jug allowing the
functioning of the appliance only when the jug and its lid are correctly placed on the
motor base. If those conditions are met and the appliance does not start, call your
after sales service.
2) Your appliance is also fitted with a security device on the lid. If the lid is not fitted
correctly, the appliance won't start.
MOUNTING OF THE BLENDER AND USE
If the blade is disassembled from the bottom of the jar, check the cleaning section for
mounting instructions before continuing.
• Put the pouring jug on the motor block and make sure the two red arrows are facing each
other, then turn clockwise until it stops.
• Lift the lid vertically and at the same time pull the knob on the upper part of the handle
towards you in order to release it.
• Fill the pouring jug with the chosen ingredients.
• Close the lid.
• Plug in the appliance.
• Choose the mixing speed with the switch on the motor base. Position 0 corresponds to
stopping the appliance, position 1 to a slow speed and position 2 to a fast speed.
• The position "P" (Pulse) is particular because the knob has to be held manually. If you
release it, the appliance stops. This position is generally used to crush ice in order to avoid
damages to the blades, but it can also be used to complete the mixing.
• It is also possible to add liquids or other ingredients anytime without stopping the
appliance. You only have to remove the cap which closes the feeding opening by turning
it and lifting it straight up.
• Once you have finished the preparation, stop the appliance (position 0) and unplug the
appliance.
• Remove the jug from the base. Then remove the lid and pour the liquid into the desired
receptacle.
• Caution: your appliance is not designed to mix hot preparations and the bowl in plastic
could break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the
whole cool down to a temperature lower than about 60°C (tepid preparation) before
pouring it into the bowl in plastic. In case the lid would come up in spite of the precautions
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/28
TEAM BL 6 - 090227