Before The First Operation; Safety Cut-Out; Cleaning And Maintenance - EFBE-SCHOTT WK 5010 Manual De Instrucciones

Fax +32 2 359 95 50
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
FIELD OF APPLICATION/OF OPERATION
•
Use the appliance for domestic purposes only and in the way indicated in these
instructions.
•
This appliance is intended to be used for domestic applications and similar applications
such as:
Kitchen corners reserved for personnel in shops, offices and other professional
environments.Farms.
The use by clients of hotels, motels and other environments with a residential
character. Environments of the "bed and breakfast" type.

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it.
•
Raise the lid and fill the tank with fresh water paying attention not to fill under the "MIN"
mark and above the "MAX" mark in the kettle. You can see the level thanks to the
transparent water level indicator.
•
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and switch on. The pilot light will
come on. If it does not come on, check if the jug kettle is placed correctly on its base. If the
problem persists, contact the nearest customer service.
•
The jug kettle will switch off automatically when the water is boiling. However, you can
switch it off anytime by pressing the on/off switch.
•
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.

SAFETY CUT-OUT

•
This jug kettle is protected with an automatic safety device which switches the appliance
off if it is accidentally switched on without water.
•
In this case, put the switch in off position and wait about 10 minutes for the element to
cool. Then fill the jug kettle with cold water. This will reset the safety device.
•
The kettle may then be used as normal.
•
Should the problem persist, please contact the nearest customer service.

CLEANING AND MAINTENANCE

•
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
To remove scale from the inner walls of the kettle and from the filter you can use a soft
brush.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
7
Assembly page 7/35
WK 5010 - 151117