nexel BFWBPR Guia De Inicio Rapido página 2

MIXING VALVE INSTALLATION
1. Apply Teflon tape, Loctite or pipe joining
compound to threads of 1/2" NPT from the
wall.
1/2" NPT
FROM THE WALL
HOT
COLD
2. Install 1/2" NPT female eccentric flanged
inlets to the 1/2"NPT thread from the wall.
3. Install coupling nut washer on 1/2" NPT
female eccentric flanged inlets. Apply
Teflon tape, Loctite or pipe joining
compound to threads of mixing valve,
then install the 8" Center wall mixing
valve. Use an adjustable wrench to tighten
the nut on the flange.
Install wall racket support
to wall bracket bar,
tighten with set screw.
5. Apply Teflon tape, Loctite or pipe joining
compound to threads of 18" long riser.
Install 18" long riser to the 8" center
wall mount mixing valve. Install the wall
bracket to the 18" long riser. Adjust the
height location accordingly. Then screw
the wall bracket to the wall with the self
tapping screws(5 x 40mm) provided.
Pre-Rinse Brass Faucet
SPINDLE BODY
6. Install the finger hook to the 18" long riser.
Adjust the height location accordingly. Apply
Teflon tape, Loctite or pipe joining compound
to threads of long body. Install spindle body to
the thread of the 18" long riser.
7. Install the spray valve hold down ring to
the stainless steel flex hose/spray valve.
Then install the stainless steel spring to
the hose.
2
FOR 761007 - PRE-RINSE HOSE
INSTALLATION WITH ADD-ON FAUCET
Repeat step 1-3
4. Apply Teflon tape, Loctite or pipe joining
compound to threads of nipple. Install nipple
to the 8" center wall mixing valve. Install
change over valve body to the nipple. Then
install the 12" swivel spout to the change
over valve body. Install add-on faucet to the
8" center wall mixing valve.
Follow step 5, the 18" long riser will be installed
to the change over valve body instead.
Turn on water supply and check for leaks.
Please make sure that all the connections
are tightened before use.
SPOUT
Install wall racket support
to wall bracket bar,
tighten with set screw.
Performance Data
Pressure: 20-60psi
NIPPLE
Temperature: 40 - 140 ˚F
Flow Rate: 1.42GPM @ 60psi
Product Compliance
NSF 61
NSF 372 (Low Lead Content)
Meets ANSI A117.1 (ADA)
HOLD
DOWN
RING
8. Install gasket between the spindle body
and the end of the hose. Apply Teflon
tape, Loctite or pipe joining compound to
threads of spindle body, then install the
hose to the spindle body.
Make sure that all the connections are
tightened before use. Turn on water supply
and check for leaks.
CHANGE
OVER VALVE
BODY
NIPPLE