Initial Power-Up - HEIDENHAIN IK 5000 QUADRA-CHEK Instrucciones De Instalación

IK 5000 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
Install the IK 5000 card
Do no touch the PCI edge connector G while installing the IK 5000 card.
Carefully plug the IK 5000 card into a PCI slot location. Limit card handling to the card
X X
edges as much as possible and secure the card with a bracket screw.
Install flyouts
Install the flyouts into the appropriate locations and secure with bracket screws
X X
Connect flyout cables to the card
Plug the internal flyout cables for the appropriate card connectors into connectors
X X
C , D , F and V with the cable connector flanges facing down. Refer to the Card,
Flyout and Connector Configuration diagrams on earlier pages for the correct and
required cable connections.
Connect the PC internal power supply to the card
Plug the 4-pin power cable from the PC internal power supply into the power connector
X X
E at the top of the card making sure that the PC power supply connector's retaining
clip is facing the card
Close the PC enclosure
Confirm that all cards, cable connections and flyouts are securely fastened and then
X X
replace the PC covers or panels
Connect all other system hardware
Refer to the Card, Flyout and Connector configuration diagram for the specific system
X X
and connect all other system hardware to the IK 5000 QUADRA-CHEK card, flyouts and
PC connectors.
Connecting a PC power cord
To connect a PC power cord:
Verify that the PC power switch is in the off position
X X
Verify that the PC power cord is not plugged into the main power supply
X X
Insert the female end of the PC power cord into the PC power connector on the rear of
X X
the PC

5. Initial power-up

Refer to the PC manufacturer's Operating Instructions for power-up instructions.
20