Chain Wheel; Cleaning; Transport; Storage - ATIKA KSH 710 SDS Manual Original

Chain wheel

The demand of the chain wheel (24) is particularly great. Check
regularly the teeth of the chain wheel for wear or damages.

A worn or damaged chain wheel reduces the durability of
the saw chain and should therefore immediately be
exchanged by the customer service.

Cleaning

Clean the power pruner carefully after each application so that
the faultless function is kept.
 Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
 Check that the ventilation slots for the motor cooling are free
(risk of overheating).
  After a longer operation period (1
the cover (5), the guide bar (1) and the chain (2) and clean
them with a brush.
 If heavily contaminated, clean the device using a
commercial chain cleaner.
  Remove all adhering substances with a brush from
the chain wheel (24) and guide bar retainers (a).
  Clean the oil flow canal (26) with a clean cloth or a
brush.
Pos. Order-No.
1 364447
2 364406
2 364437
3
4
5 364475
6
7
8 364444
9 364408
10
11
12
13
14
15
3 hours) remove
–
Description of device / spare parts 
Denomination
Guide bar (sword)
Saw chain
Saw chain
Fastening screw
Chain tension ring
Cover
Angle adjustment
Upper telescope rod
Adapter
Holding screw - Adapter
Holding screw -
Lower telescope rod
Trip switch
On/Off switch
Cable strain relief
Apparatus cable with plug

Transport

Remove mains plug before each transport.
Transport the power pruner only with the chain protection
put on.

Storage

 Store unused equipment in a dry, locked place out of the
reach of children.
 Before a longer period of storage carry out the following to
extend the power pruner
operation:
 thoroughly clean the device
 Remove the oil from the oil tank.
 Some chain oils tend to encrustations after a longer period.
For this reason the oil system should be flushed before a
longer storing with a chain saw cleaner. Fill the cleaner up to
the middle (approx. 50 ml) into the oil tank. Close the tank.
Switch on the power pruner without assembled guide bar and
chain until the complete cleaner has left the oil opening of the
power pruner.
 Put the saw chain for a short time into an oil bath and
enwrap it afterwards in an oil paper.
 Put the chain guard in place.
Pos. Order-No.
16
17 364409
18
19 364410
20 364413
21 364417
22 364415
23 364416
24 364414
25 364476
26
27
28 364412
29 364404
30 364448
31 400144
s service life and ensure an easy
'
Denomination
Rear handle
Carrying strap
Quick acting closure
Front handhold
Oil tank cap
Bushing 
Hexagonal screw M 6 x 65
Hexagonal nut M6
Chain wheel 
Clamping plate 
Oil flow canal 
Chain clamping bore 
Guide bar cover (scabbard)
Safety label
Carbon brush set (without picture)
Saw chain oil 1 l (without picture)
23