Charging The Batteries; Test Before Use; Transmission From Baby Unit / Reception On Parental Unit - Swissvoice Babycom 143 Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54

Charging the batteries

If the batteries are almost discharged, the power display on the parental
unit flashes red and an alarm signal (3 short beeps) is emitted every 3
seconds. You must charge the batteries within the next 5 minutes;
otherwise the device will automatically switch off.
Note:
- Non-rechargeable batteries must not be charged up.
- Remove discharged batteries as they can leak and damage the unit.
- No alarm signal is emitted on the baby unit when the batteries are
discharged!

Test before use

Transmission from baby unit / reception on parental unit

- Place the units in the rooms where you want them to operate.
- Switch the units on: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal is emitted and the power dis-
play lights up (green = batteries charged).
- Use the channel switch to switch the two units (parental/baby unit) to
the same channel (Channel 1 or 2).
- Set the same CTCSS code for both units: Use a pointed object (e.g.
pencil) to activate the microswitch and set the CTCSS codes (CTCSS-
Code = system for creating user groups on the same frequency).
There are 4 CTCSS combinations available, see "Table of CTCSS
Codes".
Babycom 143
45

Publicidad

Tabla de contenido
loading

Tabla de contenido