Setting Up Your Wireless Microphone - Dynex DX-M1113 Guia Del Usuario

DX-M1113.fm Page 6 Tuesday, September 19, 2006 7:07 AM
6
Setting up your wireless
microphone
The following illustration shows two basic ways to connect your receiver
to an amplifier.
Receiver
Audio mixer
Karaoke amplifier
Note: When you install the receiver, make sure that it is at
least 10 feet (3 meters) off the floor and at least 10 feet (3
meters) away from surrounding walls.
To set up the receiver:
1 Place the receiver on a flat, stable surface.
2 Fully extend the antenna, and make sure it is perpendicular
to the receiver.
3 Open the battery compartment, install two AA batteries
into the battery compartment, then close the
compartment. Make sure that the + and – symbols on the
batteries align with the + and – symbols inside the battery
compartment.
4 Plug one end of the audio cable into the AUDIO OUT jack on
the receiver.

Setting up your wireless microphone

Amplifier
Speaker
Speaker