Ryobi RY40104 Manual Del Usuario

RY40104
WIRING HARNESS REPLACEMENT
See Figures 1 - 10.
WARNING:
Carefully follow all of the steps below and avoid pinching or dam-
aging any wire insulation. Damaged wiring can result in the lawn
mower not functioning properly and cause serious personal injury
or damage to the lawn mower.
NOTICE:
The steps described in this instruction sheet should only be per-
formed by a qualified service center.
 Remove the battery pack from the mower.
 Remove the 4 screws (A) securing the bumper (B) to the deck
cover. Remove the bumper and set aside.
 Remove the 2 screws (C) securing the height adjustment handle
(D). Remove the handle and set aside.
 Remove the 10 screws (E) securing the deck cover (F) to the mower
base.
 Lift the deck cover to one side. Remove any shrink tubing and/or
zip ties securing the 2 connections (G, H) shown.
 Pull the connections (G, H) apart, then remove the deck cover
completely from the mower base.
 Disconnect the wires (I) from the key holder (J).
 Use a flat head screwdriver to lift the tab (K) and release the battery
base connector (L) from the deck cover. The old wiring harness
can now be discarded.
 On the underside of the deck cover, remove the 2 screws (M)
securing the key holder (J). Remove the key holder from the deck
cover.
 Feed the battery base connector wires (N) of the new wiring har-
ness through the opening on the deck cover so the wires are on
the underside of the cover. The battery base connector will click
into place when fully seated.
 Install the new key holder (O), tightening screws securely.
 Plug the two battery base terminals (P) into the key holder.
 Reconnect the other connections (G, H) separated previously. For
connection G, move the provided shrink tubing over the connection
and use a heat gun to shrink, or cover with electrical tape to secure.
 Reinstall the deck cover, tightening screws securely.
 Reinstall the height adjustment handle, tightening screws securely.
 Reinstall the bumper, tightening screws securely.
TECHTRONIC INDUSTRIES
POWER EQUIPMENT
P.O. Box 1288, Anderson, SC 29622 USA
1-800-860-4050 www.ryobitools.com

995000582
5-16-18 (REV:01)
A
B
Fig. 1
D
C
Fig. 2
F
E
Fig. 3
F
G
H
Fig. 4
I
J
Fig. 5
L
K
Fig. 6
M
J
Fig. 7
N
Fig. 8
P
O
Fig. 9 Fig. 10