Voice Prompt; Charging The Headphones; Customer Service; Fcc Statement - Tribit QuietPlus 78 Manual Del Usuario

EN

Voice Prompt

Power on
Power on
Power off
Power off
Pairing
Pairing
Connection Successful
Successful pairing
Disconnected
Disconnection

Charging the Headphones

Connect the USB cable to the USB port on the headphone, and a 5V power
outlet (power adapter is not included). The indicator light will glow red to
indicate charging. When the headphones are fully charged (within 3 hours),
the indicator light will change from red to white.

Customer Service

The headphones have a full 18-month warranty against manufacturing
defects starting from the purchase date. For FAQs and more information,
please email to support@tribitaudio.com.
7

FCC Statement

Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
EN
8