Publicidad
Idiomas disponibles
Idiomas disponibles
1. Entering programming mode
To enter programming mode, key in the 4 digits installer's pin code and end up
with "*" key.
Note! The factory default installer's pin code is 0 0 0 0
0+0+0+0+* => one long beep will follow to confirm.
Note: Blue LED lights on when entering programming, and it goes off when exit
programming
2. How to change installer's pin code (4 digits)
For security reasons, you can change the installer's pin code to be one of your
own, so no one else but you can only change and program the keypad in the
future..
To change new installer's pin code as follows:
a. Enter programming => one long beep follow to confirm
b. Press ( 69 ) + ( # ) for changing the new installer's code => one short beep
follow to confirm
c. Key in new 4 digits installer's pin code and end up with (#) key => one long
beep and one short beep follow to confirm.
d. Keypad exits programming mode
3. How to Program each channel's pin code (4 digits)
Keypad has 2 channels, each channel can control different receiver independently
You can choose and program each channel to a different pin code as follows:
a. Enter programming => one long beep follow to confirm
b. Key in 2 digits channels' number you would like to program
(01 for 1st channel;02 for 2nd channel) ,end up with (#) key =>the times of beep
to indicate user which channel is programming now.
(1 beep for 1st channel; 2 beeps for 2nd channel)
c. Key in the new 4 digits pin code you choose for this channel, end up with (#)
key. => one long beep and one short beep follow to confirm.
d. Keypad exits programming mode.
Example for programming 1st channel's pin code to be 2015
Entering programming: 0+0+0+0+* => one long beep follow to confirm
Choose the channels' number: 0+1+# => one short beep follow to confirm
Key in new pin code: 2+0+1+5+# => one long beep and one short beep follow to
confirm.
Note!
(1) 1st channel can be programmed with 8 groups of pin code, 2nd channel can be
programmed with 3 groups of pin code.
(2) If the pin code you programming now is already existed, the red LED indicator
would flash 5 times and then exit programming mode.
(3) After entering pin code programming, if the pin code is full programmed, the red
LED indicator would flash 5 times to indicate you that now the pin code is full
programmed, if user still key in the new pin code now within 6s, the previous
programmed pin code will be deleted, this new pin code will be 1st pin code of this
channel.
Factory default pin code for 1st channel: 1111
Factory default pin code for 2nd channel: 2222
Publicidad
