MOA AC199A Manual De Instrucciones página 6

EN
INJECT WATER IN THE TANK
Pull out the water tank from the bottom of the back and inject fair water
into it.
Please note the display of water level when injecting water .
The water level of water tank must be less than "max." when injecting
water.
The water level of water tank must be more than"min."when air cooler
is with cooling and humidify.
The frozen ice boxes (or ices) are put into water tank when the client
want to get the cooler wind.
Warning:
The water level of water tank is less than "MAX"after ice boxes( or ices)
is put water tank.
ASSEMBLY
1. Open the package and take out the air cooler, wheels, place the fan
on a flat ground.
2. Installation of Wheels: Take out the screw package, fixing the wheels
with screw by cross screwdriver. Two wheels with brakes should be
installed at the back holes and the other two wheels to the front holes.
3. Filling Water: Turn the water tank lock to horizontal position, taking
out the water tank, put in the ice boxes and add clean tap water to
large section of the tank. Be sure that water level in the tank does not
exceed the level "MAX" which is located at the back of the tank.
Your cooler takes water from narrow section of the tank and pumps it
on the cooling pad. The water flowing through the cooling pad spills
down to the large section of the tank. This cycle causes water to absorb
dust and dirt in the air. The filter at the middle of the tank filters and
cleans the water, therefore it should be attached to its place while the
device is operating.
Push the water tank to its housing and turn the tank lock to the vertical
position.
6
Aircooler - English Instruction Manual