Soba XE510 Modo De Empleo página 6

XE510 DEHUMIDIFIER
Humidity setting
When the dial is turned to the "60 %" position the dehumidifier will dehumidify to a
relative humidity of 60 %. The dehumidifier will switch off automatically as soon as
the required humidity is reached. When the ambient humidity rises over 60 %, the
dehumidifier will start up again. The same applies for any other setting. If the dial
is turned to the "CONT." position (continuous dehumidifying) the unit will continue
running until the dehumidifier unit is switched off or the water container is full, no
matter what the ambient humidity is.
Precautions
• The humidifier cannot cool like an air-conditioner. As it emits heat the room
temperature will rise by 1° C - 2° C .
• This dehumidifier can dehumidify a room area of 12m - 23m2.
• The dehumidifier is designed to operate perfectly at temperatures of 15°- 35°.
(The dehumidifier will still operate beyond this range, but efficiency will be
impaired.)
• As the room temperature falls, the dehumidifying capacity will be lowered.
TIPS: A humidity value of 65 % is usually considered comfortable. Generally, the
preferable humidity range for humans is 60 % - 75 % in summer and 55 % - 70 %
in winter.
When the water container is full
1. The dehumidifier will stop and the red 'FULL' indicator lamp will light up.
2. Slide the water container out carefully. To prevent water from spilling over, pull
the container along the groove and parallel to the floor (see diagram below).
3. Empty the water container.
4. After emptying, slide the container carefully back into the dehumidifier until it
clicks into place.
NOTES:
1. In order to avoid the compressor starting up repeatedly (this could cause
accidents) do not move the water container backwards and forwards.
2. Do not put anything inside the water container so the water level float is not
obstructed.
3. Push the water container right into the dehumidifier until it clicks into place. If the
container is not inserted properly, the dehumidifier will not start. If this happens,
remove the water container and replace it properly.
Run off through the drainage hose
1. Remove the water container.
2. Break off the cover on the condensation outlet at the back of the dehumidifier
and use a knife to scrape off any roughness at the edge.
3. Connect up a PVC drainpipe (inner diameter Ø 12 mm, not included) and fix it
firmly.
4. Replace the water container.
6
INSTRUCTIONS