Technical Specifications - Toparc 060906 Manual De Instrucciones

REPLACE THE BELT
Disconnect the compressed air supply from the sander before changing the belt.
Press the side button and slightly press the end of the sander to reduce the belt tension. Remove the damaged belt and replace it with a
new one:
1
Grain 60 (x5) : ref. 060913
Grain 80 (x5) : ref. 060920
Grain 100 (x5) : ref. 060937
2
Press the button on the side of the belt holder to pull and extend the tension bar forward to tighten the belt.
3
Use a hexagonal wrench to unscrew the screw under the sander to loosen the pin and rotate the head 360°.
4
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.

TECHNICAL SPECIFICATIONS

Band width
Belt length
Rotational speed
Length
Weight
Vibration
EN ISO 28927-3
Sound pressure level: 85.5 dB(A)
No Load:
3.2 m/s²
Sound power level: 96.5 dB(C)
Accuracy: Accuracy
K= 1.5 m/s² K= 3dB
SANDER BELT
1
2
If the belt is not centered on the bracket, turn the screw
wrench.
20 mm Noise level
520 mm Consumption
16,000 rpm Air pressure
34 cm Supply connection
1.2 kg
Noise
EN ISO 15744
3
84 db
171 l/min
6.3 bar
¼''
Always wear hearing protection in an environment where the noise
level is > 80 dB(A) due to the risk of hearing loss.
EN
4
with a hexagonal
Note
7