Specific Safety Instructions - Craftsman 151.74326 Manual Del Usuario

SPECIFIC SAFETY INSTRUCTIONS

■ Keep all parts of the body away from the
saw chain. Do not remove cut material or
hold material to be cut when saw chain is
moving. Make sure the switch is off when
clearing jammed material. A moment of
inattention while operating the pole saw may
result in serious personal injury.
■ Hold the pole saw by insulated gripping
surfaces only, because the saw chain may
contact hidden wiring. Saw chains contacting
a "live" wire may make exposed metal parts
of the pole saw "live" and could give the
operator an electric shock.
■ Keep all parts of the body away from the
saw chain when operating the pole saw.
Before you start the pole saw, make sure
the saw chain is not contacting anything. A
moment of inattention while operating may
cause entanglement of your clothing or body
with the saw chain.
■ Always hold the pole saw with both hands
on the handle. Holding the pole saw with
only one hand or on parts not intended for
that increases the risk of personal injury and
should never be done.
■ Wear safety glasses and hearing protection.
Further protective equipment for head, hands,
legs and feet is recommended. Adequate
protective clothing will reduce personal injury
by flying debris or accidental contact with the
saw chain.
■ Do not operate pole saw in a tree.
Operation of a pole saw while up in a tree
may result in personal injury.
■ When cutting a limb that is under tension
be alert for spring back. When the tension in
the wood fibers is released, the spring loaded
limb may strike the operator and/or throw the
pole saw out of control.
■ Use extreme caution when cutting brush
and saplings. The slender material may catch
the saw chain and be whipped toward you or
pull you off balance.
■ Carry the pole saw by the soft grip with
the product switched off and away from
your body. When transporting or storing the
pole saw always fit the scabbard. Proper
handling of the product will reduce the
likelihood of accidental contact with the
moving saw chain.
■ Follow instructions for lubricating, chain
tensioning and changing accessories.
Improperly tensioned or lubricated chain
may either break or increase the chance for
kickback.
■ Keep handles dry, clean, and free from oil
and grease. Greasy, oily handles are slippery
causing loss of control.
■ Cut wood only. Do not use product for
purposes not intended. For example: do not
use pole saw for cutting plastic, masonry or
non-wood building materials. Use of the pole
saw for operations different than intended
could result in a hazardous situation.
■ Pay attention to national and local
regulations. National and local regulations
may restrict the use of this product.
■ Do not operate a pole saw that is damaged,
improperly adjusted, or not completely and
securely assembled. Chain should stop
turning when the trigger switch is released.
If chain turns after the trigger switch has
been released, discontinue pole saw use
immediately. If within warranty period, return
unit to retailer of purchase for replacement.
■ Only use replacement guide bars and saw
chains as Listed in the Product Specifications
in this manual. Incorrect replacement bars
and chains may cause chain breakage and/
or kickback, resulting in personal injuries and
damage to property.
■ Never remove or modify any guard or
safety component. Ensure that guards and
other safety components necessary for
machine operation are in position, in good
working condition and properly maintained to
avoid injuries.
5 ― English