RocketFish RF-PCS7ES Manual De Instrucciones

RF-PCS7ES 7-outlet surge protector
6 ft (1.8m) Soft-Flex
cord with right-angle plug
Coaxial cable
protection
Phone line
protection
Master/AC
adapter-spaced
outlet 4 Master-Controlled outlets
Protective outlet covers
CAUTION: Risk of electric shock. Use only in dry locations and only indoors.
DO NOT plug into another relocatable power tap. DO NOT "daisy chain" surge
protectors. DO NOT use with any aquarium equipment. DO NOT use if properly
grounded outlets are not available. DO NOT install this device if there is not at least
30 feet (10 meters) or more of wire between the electrical outlet and electrical
service panel.
Features
ON/OFF Control -
also a 15A breaker. When an overload occurs, it will automatically
switch off . To resume operation,ensure the overload condition is
removed and set the switch to On.
LED indicators
protection is operating normally. If it is NOT lit, it may mean a
substantial surge event has occurred and the surge protector
should be replaced. A lit Grounded amber LED indicates the wall
outlet is properly grounded. If it is NOT lit, it means the outlet is not
properly grounded and another outlet should be used to ensure
full surge protection. When both amber LEDs are lit, it indicates
TM power
normal operation and full surge protection.
Master and Controlled by Master outlets
peripherals continue to draw power when in standby mode.
The Master and Controlled by Master outlet feature prevents
energy draw by automatically shutting off power to up to four (4)
peripherals when the computer goes into standby mode.
Note: Only connect devices to the Controlled by Master outlets that are normally
used when the master device (e.g. computer) is operating.
To use this feature, make sure the standby function on your
2 always-on outlets
computer is enabled and plug your computer into the Master
outlet, and plug peripherals (e.g. monitor, printer, scanner, and
speakers) into the Controlled by Master outlets.
When your computer goes into standby mode, power will be shut
off to peripherals plugged into the Controlled by Master outlets.
When the computer "awakens'", the surge protector immediately
supplies power to these peripherals.
• To ensure this feature works properly, enable standby mode in
your computer's power management settings. For Windows,
open the Control Panel, select Power Options, then under
Settings for Power Schemes, select a system standby time period.
For Macs, open System Preferences and select Energy Saver.
• For Audio/Video (A/V) application: plug the primary A/V device
(e.g. TV) into the Master outlet and plug peripherals (e.g. set-top
box, DVD player, and amplifi er) into the Controlled by Master
outlets.
• Some computers continue to consume more than 10W of
power in standby mode. The Master outlet may not recognize
the standby mode, and the outlets will not shut off . If this
occurs, make sure Hibernate/ Sleep mode is also enabled on
your computer under power management settings, or check
with your computer's manufacturer.
Controls power to all outlets. The switch is
– A lit Protected amber LED indicates surge
– Computer
Safety information
To ensure the safety of children and to avoid electric shock and
damage from a high-dust environment, slide the plastic outlet
cover over outlets that are not in use.
Protecting Phone/Fax/Modem
– To protect your equipment
from surges along phone/fax/modem lines, plug the phone line
from the wall outlet into the IN port and phone/fax/modem
line(s) into OUT port(s).
Protecting Coaxial Cable -
To protect your equipment from
surges, connect your coax cable from wall outlet into IN coax port
and then connect coax cable from device into OUT coax port.
Specifi cations
Seven (7) outlets
One (1) AC Adapter-spaced outlet
Phone line protection: 1 in / 2 out
Coaxial cable protection (F): 1 in / 1 out
6 ft. (1.8m) Soft-Flex™ power cord with right-angle plug
2250 Joules rating
Connected equipment warranty: $200,000
Continuous Duty Electrical Rating: 15A / 125V / 1875W
Maximum Energy Dissipation and H-N / H-G / N-G
values: 2250J / 105,000A
Maximum Spike Current and H-N / H-G value /N-G values:
6,000V / 105,000A(H-N 45,000A) (H-G 30,000A) (N-G 30,000A)
UL Clamping Voltage: UL 1449/ 330V(L-N)400V(L-G,N-G)
Response Time: Less than 1 nanosecond
EMI/RFI Noise Filtration: 150K Hz - 100M Hz, Up to 43dB
One Year Limited Warranty
Visit www.rocketfi shproducts.com for details
RoHS compliant
ENGLISH 09-0259