Lorell LLR13201 Instrucciones De Ensamble

Assembly Instructions
SPECIFICATION
Bulb Replacement:
Adaptor Spec.:
WARNING:
To Reduce the Risk of Fire, Electric Shock, or Injury to Persons:
• Lamp is for indoor use only.
• Use the unit only with the accessories delivered with the lamp.
• Avoid eye contact with bulbs: when lit.
• If the supply cord or adaptor is damaged, it must be replaced by a service agent or a similarly qualified person in order to
avoid a hazard.
• LED Module is irreplaceable.
• Do not continue to touch the lamp or bulb if skin feels warm
• Keep lamp away from materials that may burn
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions :(1)This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Modifications not approved by the party responsible for compliance could void user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
OPERATION PROCEDURE: IMPORTANT
1. Lay out all parts on smooth surface as shown in illustration.
2. Insert the adaptor into lamp.
3. Plug the adaptor into power outlet
4. Push the panel on the front of the base (see image below) where indicated
until it rotates 180 degrees.
5. "Tap" on the switch to turn lamp on.
6. Adjust the brightness of the lamp by tapping the "touch" switch.
7. To turn off lamp, tap the "touch" switch
USB Docking Station & Charging Port:
Output: 5Vdc Max 750mA
Use to dock and charge small personal "smart" devices such as cell phones, MP3 players and tablets. Insert device into
docking station and attach USB charging cord to device. Plug into USB port at rear of lamp base to charge device.
On larger devices which consume more power, such as an Ipad Air, the charging sign may not immediately appear upon
connection to the charging port. In other cases some devices, regardless of size, may not appear to be charging. However,
approximately 10 minutes after connecting to the port, you should begin to notice the device batter
Care and Maintenance
Always ensure the product is unplugged from the electrical outlet and allowed to cool before assembling, disassembling,
relocating, servicing, or cleaning it.
Clean the product with a soft cloth; do not use liquids, abrasive cleaners, or solvents.
®
LED module is irreplaceable
Input:100-240V~50/60Hz 0.3A
Output : DC 18V, 700mA
Desktop Task Light
LLR13201/13202