Quantum DLT-V4 Guia De Inicio Rapido página 4

DLT-V4 Tape Drive Quick Start Guide
9 USB/eSATA Tape Drives Only — Connect the USB or
eSATA cable to the tape drive and to the USB or eSATA
port on your computer (see
N : USB Tape Drives Only — For optimum
OTE
performance, the USB tape drive should be
connected to a USB 2.0 port and be the only
device on the root hub.
Figure 8 Connecting the Cables
— USB/eSATA Tape Drive
eSATA
USB
cable
cable
Install EITHER
(not both)
10 Ensure that the power switch on the rear panel of the
tape drive is in the OFF position. Connect the power
cable to the tape drive and plug the power cable in to
the nearest power outlet (see
11 Connect the power cables to the host server or
workstation and all peripheral devices.
12 Power on the tape drive and any attached peripheral
devices.
13 Power on the server or workstation and allow its
operating system to start.
figure 8).
On
Off
Power
cable
figure 7 or figure 8).
4