Parts Included - Henn&Hart TL0291 Instrucciones

PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective plastic packaging.
Do not discard any contents until after assembly is complete to avoid accidentally
discarding small parts or hardware.
A
B
C
D
E
Attach the Socket/Bracket (B) to the Base
Post (E), taking extra care not to strip the
threads.
Screw in the specified light bulb.
Loosen Nut (D) to separate the Shade
Base (C) from the Socket/Bracket (B).
ANGLE and carefully place the Shade
(A) OVER the Socket/Bracket (B). The
Socket/Bracket should be inside the
Shade (A).
Replace the Shade Base (C) up in the
correct position to secure the Shade (A)
against the Bracket (B).
Secure the Shade Base (C) into position by
turning the Nut (D). Tighten fully by hand.
Made in China

PARTS INCLUDED:

(A) Shade
(B) Socket/Bracket
(C) Shade Base
(D) Nut
(E) Base
(F) On/Off Control
For use with light bulbs
with a E26 (medium) base.
Pictured with:
F
DO NOT EXCEED THE
SPECIFIED WATTAGE.
THIS BRACKET
GOES INSIDE
THE SHADE
TO SECURE IT
2
A19
Standard
E26 (medium) base
(Not included)
A
B
C
D
E