WeatherHawk MyMET Manual Del Usuario página 3

myMET Manual V 1.00 — English
Product Description
Your myMET Hand Held Wind Meter measures wind speed
and air temperature, and calculates wind chill. It then
displays that information on the integral LCD, and transmits
the information in real-time to a BLE iOS or Android device
within range. NOTE: iPhone 4S or later, iPad2 or later, or
Android 4.2 devices are supported. If the display device has
the myMET APP it can display the data, and add additional
information, such as wind direction, user location and
altitude. All of the information can be tagged with an image
and transmitted, using the methods available to the display
device.
Getting Started
Your myMET Hand Held Wind Meter package contains a
myMET, two Lithium CR2032 batteries (installed), and a
lanyard. BATTERIES: The batteries are factory installed.
LANYARD: To install the lanyard, feed the small loop
through the hole at the bottom corner of the case, and
then feed the lanyard through the loop. myMET USE:
Extend myMET to the fully opened position. If using a
tripod, attach it at the bottom of the case. NOTE: The
optional wind vane accessory will align myMET with wind
direction when it is tripod mounted and properly leveled.
Hold myMET at the bottom of the case, away from your
face and body, to avoid getting false readings. Your
myMET sensors are sensitive. For good measurements it is
important that you do not touch, or obstruct, the sensors.
Operating Modes:
Turn myMET on by extending the
meter, or using the power button.
The power button is used when
myMET is extended but the auto-off
function has occurred. You also use
the power button to scroll to display
the desired measurement, or
function. To turn off myMET, push
the wind meter into the case.
Disabling the Power Save mode:
With the myMET on, change power
saving mode to always on mode by
pressing the power button for 3
seconds until "n" appears on the LCD,
then release the power button. The
"APO" icon will disappear from the
LCD while in always on mode.