Auto Mode - SYNQ SMX-1 Manual Del Usuario

USER MANUAL
10. CROSS FADER ASSIGN BUTTONS: The left side of the cross fader is named
"A", the right side is named "B". Every input channel has 2 assign buttons, also
named "A" and "B". You can easily determine if the signal of a certain channel will
be routed to the left or right side of the cross fader, just by pushing the assign
button with the corresponding name: "A" or "B". The selected button will be lit.
11. CROSS FADER: Used to mix the signals from the 2 channels assigned to A and B
by the cross fader assign buttons.(10)
12. MASTER OUTPUT FADER: Adjusts the output level of the master output.
(Attention: the "trim output" on the back of the mixer can reduce the maximum
output level of the master output fader. Check this trimmer if the maximum output
level is below normal. In this case please also check if the talk over is switched off)
13. ZONE LEVEL: Used to adjust the level of the ZONE output on the rear panel. Its
level is not affected by the master volume (12) and master balance (37). This
output can be used as a second master.
14. CROSSOVER EFFECTS UNIT: To take full advantage of the crossover effects it is
absolutely necessary to connect a compatible CD-player to the fader output
connectors (see previous chapter n°5). The 3 effects give you additional
possibilities for perfect, beat synchronized mixing! Please read the text below to be
sure you fully understand how it works!
IMPORTANT:
• You must put the "fader start on/off switches" (8) in ON-position.
• You must assign two channels to A and B with the assign buttons (10)
15. CROSSOVER EFFECT MODE SWITCH: Used to select the desired crossover
effect mode:
• FADER: In this mode you can use the cross fader to control the crossover
effects and perform start/stop (recue) functions.
• OFF: Crossover effects are disabled.
• AUTO: In this mode you don't have to use the cross fader: simply push one
of the buttons and the mix will be done automatically in full beat sync!
16. CROSSOVER EFFECT SELECT/START BUTTONS: Used to select the type of
Effect Mix desired, 3 functions (Echo, Zip and Roll) are available:
• ECHO EFFECT: This effect can be used in FADER and AUTO mode:
• FADER MODE: Press the echo effect button and move the cross fader
from one end to the other. A part of the music is sampled and
constantly looped while the volume decreases until the other player
starts automatically. The echo effect is fully beat synchronized. The
length of the loop can be adapted with the "Preset" buttons (24). You
can use the following presets: ¼ ~ ½ ~ 1/1 ~ 2 ~ 4 ~ 8 beats. The
effects display shows the length of the sampled loop.
Hint: If you just move the cross fader a little from the end position, you can repeat a
small portion of the music to the rhythm of the beat. (Depending on the preset you
choose) You can move the cross fader back to the same end position to stop the
repeated sounds without actually mixing two channels.
• AUTO MODE: While the music is playing, press the "echo effect"
button. The music starts playing in a loop while the volume decreases
automatically until the other player starts. The length of the complete
fade over is shown on the effects display. It can be adapted with the
"preset" buttons (24) and/or the "time parameter knob" (33).
SYNQ 5/63
ENGLISH
SMX-1 DJ-MIxer