QNAP QSW-M408 Serie Guía De Instalación Rápida página 4

Accessing the Web User Interface
EN
The QSW-M408 series supports DHCP client by default. When connected to a network, the switch will obtain an
IP address from a DHCP server automatically. You can then use Qfinder to locate the switch and access the web
user interface.
If your network is not connected to a DHCP server, you can access the web user interface by changing your
computer ' s IP address to 169.254.100.102.
The default IP address of the QSW-M408 is 169.254.100.101
Note: After configuration, ensure that you change your computer's IP address back to the original setting.
Web User Interface Login
Default username: admin
Default password: same as MAC Address
When logging in for the first time, you will be prompted to set a new username and password. QNAP
strongly recommends setting a new username and password for security purposes.
1 3 5 7
SFP+ SFP+
2 4 6 8 9
1 2 3
LED Behavior
LED Status
Flashing
System Status
Green
Off
Green (Left)
Amber (Right)
RJ45
Flashing
Off
Green
SFP+
Flashing
Off
Green (SFP+)
Green (RJ45)
Amber (RJ45)
SFP+/RJ45 Combo
Flashing
Off
SFP+ 11 SFP+ 12
10
4
Description
Device is booting.
Device is booted.
Device is powered off.
Link is operating at 1 Gbps.
Link is operating at 100/10 Mbps.
Network is active.
No link.
Link is operating at 10/1 Gbps.
Network is active.
No link.
Link is operating at 10/1 Gbps.
Link is operating at 10 Gbps.
Link is operating at
5Gbps/2.5Gbps/1Gbps/100Mbps.
Network is active.
No link.