Control Elements; Low Battery Indicator - Nacon MG-X Manual De Instrucciones

I

Control elements

View Button
LB / LT
Stick gauche
D-pad
USB-C charging port
I Turning the controller on/off
To turn on the controller, simply press the Nexus button, and the controller will connect
to the last phone it was synced with.
To turn off the controller, simply hold down the Home button for 6 seconds.
Please note: the controller turns off after 15 minutes of inactivity to save battery power.
I Syncing your Android phone with the Nacon MG-X controller
Go to the Bluetooth menu on your phone and start a Bluetooth device search.
Press the Nexus button on your controller, and the player indication LED should start
flashing steadily.
Press and hold the Bluetooth button on the lower right-hand side for 3 seconds to initiate
pairing. The player indicator LED should start flashing rapidly.
On your phone, you should see the controller appear under the name 'Nacon MG-X',
select it and wait until the controller is in the list of paired devices.
I

Low battery indicator

When the battery is low, the battery LED flashes red slowly.
When the battery is very low, the battery LED flashes red quickly.
I Recharging the controller
The controller is equipped with an internal battery. To charge this battery, take the USB-C
cable that comes with the controller and plug it into the charging socket/port (located
below the D-pad). Then plug the other end into one of the free USB ports on your PC. The
Red LED will stop flashing. Once recharged, the LED will turn green and turn off when the
cable is unplugged.
RB / RT
Menu Button
Action buttons
Battery LED
Right joystick
Player indication LED
Nexus Button
Bluetooth sync button
EN /